MCQOPTIONS
Saved Bookmarks
MCQOPTIONS
This section includes 8 Mcqs, each offering curated multiple-choice questions to sharpen your Petroleum Production Operations knowledge and support exam preparation. Choose a topic below to get started.
| 1. |
Which of the following is correct for Mechanical Cutters in Perforation? |
| A. | Knives and milling tools are used |
| B. | Doesn’t make communication between the wellbore and the formation |
| C. | Doesn’t control sand |
| D. | Milling tools are not used |
| Answer» B. Doesn’t make communication between the wellbore and the formation | |
| 2. |
Which of the following is correct for Hydraulic perforator? |
| A. | Hydraulic Perforation is Hydraulic fracturing |
| B. | Perforation is obtained by fracturing |
| C. | Cutting is obtained by edging sand-laden fluid through an orifice |
| D. | Penetration is too high |
| Answer» D. Penetration is too high | |
| 3. |
What is a perforated liner? |
| A. | A wellbore tubular with slots |
| B. | A wellbore tubular with no slots |
| C. | Seals the gun |
| D. | Seals the fluid to enter into the gun |
| Answer» B. A wellbore tubular with no slots | |
| 4. |
Bullets cost is much higher than Jet perforator. |
| A. | True |
| B. | False |
| Answer» C. | |
| 5. |
What is Fluid Seal Disks? |
| A. | Helps to ignite the prima cord |
| B. | Allows fluids to enter into the gun |
| C. | Allows bullets to enter into the formation |
| D. | Prevents fluids from entering into the gun |
| Answer» E. | |
| 6. |
What is the size of the depth of penetration of a standard perforation? |
| A. | 10 inch |
| B. | 12 inch |
| C. | 20 inch |
| D. | 5 ft |
| Answer» D. 5 ft | |
| 7. |
What is the size of the hole of a standard perforation? |
| A. | 0.1 inch |
| B. | 0.3 inch |
| C. | 0.6 inch |
| D. | 0.4 inch |
| Answer» E. | |
| 8. |
The bullet loses its energy and velocity when the gun clearance exceeds ______ |
| A. | 0.5 in |
| B. | 0.5 mm |
| C. | 0.5 cm |
| D. | 0.5 ft |
| Answer» B. 0.5 mm | |