The maximum eccentricity in the design of composite sections is given – McqOptions

MCQOPTIONS

1.	The maximum eccentricity in the design of composite sections is given as ____________
A.	e = ZtZb(Pt) / A(PbZt+PtZb)b) e = ZtZb(Pt-Pb) / A(PbZt+PtZb)c) e = ZtZb(Pt+Pb) / A(PbZt+PtZb)d) e = ZtZb / A(PbZt-PtZ
B.	e = ZtZb(Pt-Pb) / A(PbZt+PtZb)
C.	e = ZtZb(Pt+Pb) / A(PbZt+PtZb)
D.	e = ZtZb / A(PbZt-PtZb)
Answer» C. e = ZtZb(Pt+Pb) / A(PbZt+PtZb)

Discussion

No Comment Found

Related MCQs

The maximum eccentricity in the design of composite sections is given as ____________
The bottom fiber of the prestressed beams is expressed as ____________
The prestressing tendons are not grouted in the case of ____________
The prestressing steel, sheathing and anchorages should be stored at ____________
The coupling units are used in prestressing steel for ____________
In typical detail of expansion joint the open cell compression seal is dependant upon its ability to maintain ____________
Under minimum and maximum moments the critical stresses occur at ____________
The design considerations of composite section in step 3 and step 4 are ____________
The first two factors considered in design considerations of composite sections are ____________
The critical stress condition generally occurs at ____________