What is the best combination of fluidized bed for fluid catalytic crac – McqOptions

MCQOPTIONS

1.	What is the best combination of fluidized bed for fluid catalytic cracking?
A.	Spouted and teeter bed
B.	Teeter and one pass for solids bed
C.	Batch type and spouted bed
D.	Batch type and circulation bed
Answer» E.

Discussion

No Comment Found

Related MCQs

In a fluidized bed reactor, what is the best way to achieve maximum heat and mass transfer rates?
What is the mesh range of particles required in the fluidized bed for best efficiency?
In pneumatic transport, explain the importance of the classification of solids before its application has been started?
In a fluidized bed reactor, for a specific gas flow rate, any kind of Geldart type particles can be used. True of False?
There is a missing part in the fluidized bed construction shown in figure.1, state the required equipment and if any replacement for that part and possible explanation?
In case of naphtha cracking, use of batch type is better than circulation type fluidized bed?
What is the advantage of fluidized bed over spouted bed and teeter bed in the drying process?
What is the maximum range of superficial gas velocity when the TDH of the bed is 0.25m to prevent eluitrition in a circular type fluidized bed reactor?
What is the best combination of fluidized bed for fluid catalytic cracking?
What is the most important factor to be considered for designing a fluidized bed reactor?