To control dust in the foundry during casting processes, it is dumped – McqOptions

MCQOPTIONS

1.	To control dust in the foundry during casting processes, it is dumped or mixed with water to reuse it for the preparation of mould.
A.	True
B.	False
Answer» B. False

Discussion

No Comment Found

Related MCQs

The study of ergonomics basically does not require as almost the entire foundry operations are performed by automation or mechanization.
Casting of non-ferrous alloys by continuous casting method can cause an explosion if the casting contacts with water during processes.
Protective cloths are worn by the workers to resist the radiation of heat in the foundry.
Which of the following operations in the production of castings gives rise to excessive noise in the foundry?
In foundry during casting processes, carbon monoxide gas is produced only by the furnaces.
Which of the following processes is used for recycling of silica sand or dust in foundry during the casting process?
To control dust in the foundry during casting processes, it is dumped or mixed with water to reuse it for the preparation of mould.
Which of the following hazards presence in the foundry is responsible for lung disease to the workers?
Improper controlling of hazards in the foundry can lead to the occurrence of serious health problems to the workers.
In working at the foundry, the risk of getting injuries is inversely proportional to the frequency of exposure to the worker.