The higher order wave guide modes of propagation can be avoided in – McqOptions

MCQOPTIONS

1.	The higher order wave guide modes of propagation can be avoided in a strip line by:
A.	Restricting both the ground plate spacing and the sidewall width to less than λd/2
B.	Restricting both the ground facing plate spacing and the sidewall width to less than λd
C.	Filling the region between 2 plates with di electric
D.	Restricting both the ground plate spacing and the sidewall width between λg and λg/2
Answer» B. Restricting both the ground facing plate spacing and the sidewall width to less than λd

Discussion

No Comment Found

Related MCQs

Fields of TEM mode on strip line must satisfy:
If the dielectric material used between the grounded plates of a stripline is 2.2, when the strip line operating at 8 GHz, the wavelength on stripline is:
If the loss tangent is 0.001 for a stripline operating at 12 GHz with the relative permittivity of the dielectric material being used equal to 2.6, then the conductor loss is:
The wave number of a stripline operating at a frequency of 10 GHz is:
If the effective width of the center conductor is 3 mm and the distance between the two ground plates is 0.32 cm with the material of the dielectric used having a relative permittivity of 2.5, then what is the characteristic impedance of the strip line?
The expression for characteristic impedance Zₒ of a stripline is:
If the phase velocity in a stripline is 2.4*108m/s, and the capacitance per unit length of a micro stripline is 10pF/m, then the characteristic impedance of the line:
Expression for propagation constant β of a strip line is:
If the dielectric material filled between the round plates of a microstrip line has a relative permittivity of 2.4, then the phase velocity is:
The higher order wave guide modes of propagation can be avoided in a strip line by: