MCQOPTIONS
Home
About Us
Contact Us
Bookmark
Saved Bookmarks
Testing Subject
General Aptitude
Logical and Verbal Reasoning
English Skills Ability
Technical Programming
Current Affairs
General Knowledge
Finance & Accounting
GATE (Mechanical Engineering)
Chemical Engineering
→
Embedded Systems
→
Formal Verification
→
One half value layer of lead for Cobalt-60 is appr...
1.
One half value layer of lead for Cobalt-60 is approximately:
A.
12 mm
B.
6 mm
C.
2 mm
D.
25 mm
Answer» B. 6 mm
Show Answer
Discussion
No Comment Found
Post Comment
Related MCQs
Where severe synchronising swing occur, the relay employed is
Requirements of protection power station buildings against direct strokes are
For the protection of power station buildings against direct strokes therequirements are
The current zero interruption, in oil and air blast circuitbreakers, is achieved by
The most efficient torque producing actuating structure for the induction typerelays is
Differential relays are used for protection of
Directional over current relays have two exciting coils connected across
A three phase, 33 kV oil circuit breaker is rated 1200 A, 2000 MVA, 3s. What isits symmetrical breaking current?
Which of the following medium is employed for extinction of arc in air circuitbreaker ?
Which among these tests are performed to check the nation or internationalstandards?
Reply to Comment
×
Name
*
Email
*
Comment
*
Submit Reply
Your experience on this site will be improved by allowing cookies. Read
Cookie Policy
Reject
Allow cookies
