In which of the following, tail stock method of taper turning operatio – McqOptions

MCQOPTIONS

1.	In which of the following, tail stock method of taper turning operation will be preferred more?
A.	Internal tapers
B.	Steep tapers
C.	Small tapers
D.	Long slender tapers
Answer» E.

Discussion

No Comment Found

Related MCQs

In surface finishing operation one should use a sharp tool with a ______ feed and _______ Speed of rotation of the job.
Which of the following can produce both external as well as internal threads?
Which of the following is used to produce quality screw threads?
Which of the followings is the correct type of threads used in lead screw having half nut in the lathe which is free to rotate in both directions?
In which of the following, tail stock method of taper turning operation will be preferred more?
Compound rest swiveling method in taper turning operation is most suitable for
Facing of work piece of diameter 72mm is need to be done at spindle speed of 80 rev per min at cross feed of 0.3mm/rev. The time required in minute for facing operation will be
If cutting tool travel 1000mm in the direction of feed motion with work piece rotational speed of 500 rpm and feed rate of 0.2mm/rev, machining time in minutes will be
Which of the following is the correct basis in designing feed gear box for screw cutting?
Which of the following is correct about series of range of speed in simple lathe?