In the Standard Penetration Test, the split spoon sampler is penetrated into soil stratum by giving blows from a drop weight whose weight (in kg) and free fall (in cm) are respectively

In the Standard Penetration Test, the split spoon sampler is penetrate

1.	In the Standard Penetration Test, the split spoon sampler is penetrated into soil stratum by giving blows from a drop weight whose weight (in kg) and free fall (in cm) are respectively
A.	65 and 75
B.	75 and 65
C.	65 and 30
D.	30 and 65
Answer» B. 75 and 65

Discussion

No Comment Found

Related MCQs

In the Standard Penetration Test, the split spoon sampler is penetrated into soil stratum by giving blows from a drop weight whose weight (in kg) and free fall (in cm) are respectively
Based on the rock mass rating (RMR), a rock having a value ranging between 41 - 60 will be rated as
In a core drilled for 100 m, the following fragments were obtained - 24 m, 12, 11, 9, 22, 8, 12 and loose rock. The RQD of the rock is
During compaction the quantity of water at which the maximum density is obtained is known as:
Consider the following statements related to the properties of a good quality soil sample:1. Area ratio should be low2. Cutting edge should be thick3. Inside clearance should be high4. Outside clearance should be lowWhich of the above statements are correct?
Auger boring is suited for which of the following exploratory strata?
Mechanical stabilization requires
For the following statements:P – The lateral stress in the soil while being tested in an oedometer is always at-rest.Q – For a perfectly rigid strip footing at deeper depths in a sand deposit, the vertical normal contact stress at the footing edge is greater than that at its center.R – The corrections for overburden pressure and dilatancy are not applied to measured SPT-N values in case of clay deposits.The correct combination of the statements is
In order to obtain a good quality of undisturbed soil the area ratio of the sampling tube should be
Match List-I (Type of exploration) with List-II (Soil profile) and select the correct answer using the codes given below the lists:List-IA. Diamond Core drillingB. Open pit excavationC. Uncased wash boringD.Cased boringList-II1. Medium-strong cohesive soils2. Soft cohesive soils and cohesionless soils, for large depths3. Rocky formation4. Exploration up to a shallow depth below ground level.

In the Standard Penetration Test, the split spoon sampler is penetrated into soil stratum by giving blows from a drop weight whose weight (in kg) and free fall (in cm) are respectively

Discussion

No Comment Found

Related MCQs

Reply to Comment