In pneumatic control systems the control valve used as final control e – McqOptions

MCQOPTIONS

1.	In pneumatic control systems the control valve used as final control element converts
A.	Pressure signal to electric signal
B.	Pressure signal to position change
C.	Electric signal to pressure signal
D.	Position change to pressure signal
Answer» C. Electric signal to pressure signal

Discussion

No Comment Found

Related MCQs

Assertion (A): Lead compensation is used to improve the system’s stabilityReason (R): Lead compensation achieves the desired result through the merits of its phase lead contribution.
A plant is controlled by a proportional controller, if time delay element is introduced in the loop its:
Assertion (A): A derivative controller produces a control action for constant error only.Reason (R): The PD controller increases the damping and reduces the peak overshoot.
Assertion (A): A PI controller increases the order of the system by units but decreases the steady state error.Reason (R): A PI controller introduces a pole at either the origin or at a desired points on the negative real axis.
Assertion (A): Feedback compensation is preferred to series compensation.Reason (R): No amplification is required as the energy flows from higher to lower levels.
A_PLANT_IS_CONTROLLED_BY_A_PROPORTIONAL_CONTROLLER,_IF_TIME_DELAY_ELEMENT_IS_INTRODUCED_IN_THE_LOOP_ITS:?$
Assertion_(A):_Lead_compensation_is_used_to_improve_the_system‚Äö√Ñ√∂‚àö√ë‚àö¬•s_stability$#
Assertion (A): A derivative controller produces a control action for constant error only?
Assertion (A): A PI controller increases the order of the system by units but decreases the steady state error.
Assertion (A): Feedback compensation is preferred to series compensation.