In basins subjected to strong winds and tide, the length of the berthi – McqOptions

MCQOPTIONS

1.	In basins subjected to strong winds and tide, the length of the berthing area should not be less than____________________?
A.	the length of design vessel
B.	the length of design vessel + 10% clearance between adjacent vessels
C.	the length of design vessel + 20% clearance between adjacent vessels
D.	twice the length of design vessel
Answer» D. twice the length of design vessel

Discussion

No Comment Found

Related MCQs

Which of the following structures are constructed parallel to shore line to develop a demarcating line between land area and water area ?
When a wave strikes a vertical breakwater in deep water, it is reflected back and on meeting another advancing wave of similar amplitude merges and rises vertically in a wall of water. This phenomenon is called_________________?
When a ship floats at its designed water line, the vertical distance from water line to the bottom of the ship is known as________________?
The significant wave height is defined is the average height of the_________________?
The minimum diameter of turning besin, where ships turn by going ahead and without tug assistance should be___________________?
The maximum harbour depth below lowest low water is generally equal to_________________?_x005F_x000D_(i) loaded draft + 1.2 m when bottom is rock_x005F_x000D_(ii) loaded draft + 1.8 m when bottom is soft_x005F_x000D_(iii) loaded draft + 1.2 m when bottom is soft_x005F_x000D_(iv) loaded draft + 1.8 m when bottom is rock_x005F_x000D_select the correct the correct statements.
The difference in height between highest high water and lowest low water is called_______________?
Minimum width of ship clearance shall be__________________?
In multiple point mooring system, vessel is secured to minimum of____________________?
In basins subjected to strong winds and tide, the length of the berthing area should not be less than____________________?