In an oscilloscope screen, Linear sweep signal is applied at the – McqOptions

MCQOPTIONS

1.	In an oscilloscope screen, Linear sweep signal is applied at the
A.	Vertical axis
B.	Horizontal axis
C.	Origin
D.	Both vertical and horizontal axis
Answer» C. Origin

Discussion

No Comment Found

Related MCQs

In an oscilloscope screen, Linear sweep signal is applied at the
A 1000 Hz sinusoidal voltage is connected to both X and Y inputs of a CRO. Which of the following waveforms is seen on CRO ?
A stationary closed Lissajous pattern on an oscilloscope has 3 horizontal tangencies and 2 vertical tangencies for a horizontal input with frequency 3 kHz. The frequency of the vertical input is
CRO (Cathod Ray Oscilloscope) CANNOT be used to measure _______.
Decibel scale is useful while measuring voltages covering
A voltage of 6 cos(100πt) V is fed as y-input to a CRO. The waveform seen on the screen of the CRO is shown in the figure. The Y and X axes settings for the CRO are respectively
Astigmatism control on CRO panel is used for ______ control.
One cycle of square wave signal observed on an oscilloscope is found to occupy 6 cm at a scale setting of 30 μs/cm. What is the signal frequency?