For the circuit shown diode cutting voltage is Vin = 0. The ripple vo – McqOptions

MCQOPTIONS

1.	For the circuit shown diode cutting voltage is Vin = 0. The ripple voltage is to be no more than vrip = 4 V. The minimum load resistance, that can be connected to the output is (in kilo ohm)
A.	6.25
B.	12.5
C.	25
D.	30
Answer» B. 12.5

Discussion

No Comment Found

Related MCQs

The Q-point of the zener diode in the circuit shown below is
The circuit inside the box in fig. P3.1.31. contains only resistor and diodes. The terminal voltage vo isconnected to some point in the circuit inside the box. The largest and smallest possible value of vo most nearly to is respectively
For the circuit shown diode cutting voltage is Vin = 0. The ripple voltage is to be no more than vrip = 4 V. The minimum load resistance, that can be connected to the output is (in kilo ohm)
The maximum load current that can be drawn is
The_time_constant_of_a_series_RL_circuit_(‚âà√¨‚àö√´)_is_given_by$#
A circuit is so formed such that source-R-L-diode-switch are all in series. Consider the initial current in L to be zero. The diode is so connected that it is forward biased when switch is closed.
The time constant of a series RC circuit (‚âà√¨‚àö√´) is given by$
A circuit is so formed such that the source-R-C-diode-switch are in series. Consider the initial voltage across the C to be zero. The diode is so connected that it is forward biased when the switch is closed. When the switch is closed,
An ideal diode has _________ &__________