Failure of slopes occurs only when a total shear force is

1.	Failure of slopes occurs only when a total shear force is
A.	Equal to total shear strength
B.	Greater than total shear strength
C.	Less than the total shear strength
D.	None of these
Answer» C. Less than the total shear strength

Discussion

No Comment Found

Related MCQs

A 10 m deep canal is constructed in purely cohesive soil having c = 0·2 kg/cm2, θ = 0°, G = 2·5, e = 0·5. The stability number is 0·1. In a canal running in full condition, the factor of safety w.r.t. cohesion against failure of side slopes will be
Failure of slopes occurs only when a total shear force is
In a clayey soil having 50 kN/m2 as unit cohesion and 18 kN/m3 as unit weight, an excavation made with a vertical face. Taking Taylor’s stability number as 0.261, what is the maximum depth of excavation so that the vertical face remains stable?
For the construction of a highway a cut is to be made as shown in the figure.The soil exhibits c’= 20 kPa, ϕ’ = 18°, and the undrained shear strength = 80 kPa. The unit weight of water is 9.81 kN/m3. The unit weights of the soil above and below the ground water table are 18 and 20 kN/m3, respectively. If the shear stress at Point A is 50 kPa, the factors of safety against the shear failure at this point, considering the undrained and drained conditions respectively, would be
During stability analysis, the term mobilised shear strength means
In a reinforced concrete retaining wall, a shear key is provided if the
An embankment in clayey soil of 5 m height is to be constructed using factor of safety of 2.5. It is to be assumed that stability number is 1/45 and unit weight of soil is 18 kN/m3. Find the minimum cohesive strength (in kN/m2) which the soil should have. Choose correct answer from the following:
In a reinforced concrete retaining wall, shear key is provided if
Instability analysis of slopes, factor of safety with respect to height is given by
For stability analysis of slopes of purely cohesive soils. the critical centre is taken to lie at the intersection of

Failure of slopes occurs only when a total shear force is

Discussion

No Comment Found

Related MCQs

Reply to Comment