Creep error may occur induction type energy meter due to

1.	Creep error may occur induction type energy meter due to
A.	incorrect position of brake magnet
B.	incorrect adjustment of position of shading band
C.	overvoltage across voltage coil
D.	increase in temperature
Answer» D. increase in temperature

Discussion

No Comment Found

Related MCQs

An energy meter is designed to have 100 revolutions of the disc per unit of energy consumed. The energy consumed by the load-carrying 50 A at 230 V and 0.8 power factor. Find the percentage error if the meter actually makes 950 revolutions.
Boards on which various control accessories like energy meter, iron-clad switch, fuses, etc. are housed are called ______ boards.
Direction: It consists of two statements, one labeled as ‘Statement (I)’ and the others as ‘Statement (II)’. You are to examine these two statements carefully and select the answer using the codes given below: Statement (I): A Watt-hour meter must be calibrated at both full-rated load as well as at 10% of rated load.Statement (II): The source of error at full load is inaccurate damping and at light loads, the torque is not exactly proportional to load.
Creep error may occur induction type energy meter due to
If an energy meter disc makes 10 revolutions in 100 sec when a load of 450 W is connected to it, the meter constant (in rev / kW-h) will be:
A domestic load consists of 10 lamps of 100 W each, three fans of 60 W each and two heaters of 1 kW each, all the loads operating for 1 hour. Energy consumed is measured using an energy-meter having a constant of 1500 revolutions per kWh. The number of revolutions recorded by the meter is 4500. The percentage error in the energy-meter reading is:
Creeping in energy meter can be avoided by:
A single phase energy meter is operating on 230 V, 50 Hz supply with a load of 20 A for two hours at UPF. The meter makes 1380 revolutions in that period. The meter constant is
A 230 V, 1-phase watt hour meter records a constant load of 10 A for 10 hours at unity p.f. If the meter disc makes 2300 revolutions during this period, what is the meter constant in revolutions/kWh?
In an induction-type instrument, two fluxes having a phase difference θ from a single phase supply can be achieved by:

Creep error may occur induction type energy meter due to

Discussion

No Comment Found

Related MCQs

Reply to Comment