An automobile moving at a velocity of 40 km/hr is experiencing a wind resistance of 2 kN. If the automobile is moving at a velocity of 50 km/hr, the power required to overcome the wind resistance is

An automobile moving at a velocity of 40 km/hr is experiencing a wind

1.	An automobile moving at a velocity of 40 km/hr is experiencing a wind resistance of 2 kN. If the automobile is moving at a velocity of 50 km/hr, the power required to overcome the wind resistance is
A.	43.1 kW
B.	3.125 W
C.	2.5 kW
D.	27.77 kW
Answer» B. 3.125 W

Discussion

No Comment Found

Related MCQs

One feels heavier in a lift when the lift
An automobile moving at a velocity of 40 km/hr is experiencing a wind resistance of 2 kN. If the automobile is moving at a velocity of 50 km/hr, the power required to overcome the wind resistance is
A man, 65 kg, descends to the ground with the help of a parachute, 18 kg. The parachute is hemispherical in shape, 2 m diameter. Density of air can be taken as 0.00125 g/cm3 and its kinematic viscosity as 0.15 stoke. What is the terminal velocity of the parachute?(Take OD – 1.5 and g – 1000 cm/sec2)
A vertical air stream flowing at a velocity of 100 m/s supports a ball of 60 mm in diameter. Taking the density of air as 1.2 kg/m3 and kinematic viscosity as 1.6 stokes, the weight of the ball that is supported is (if coefficient of drag CD = 0.8)
In calculating the drag force using CD the are used is
An airfoil of surface area 0.1 m2 is tested for lift L m a wind tunnel. (Conditions can be considered as incompressible flow.) At an angle of attack of 5°, with standard air of density 1.22 kg/m3, at a speed of 30 m/sec, the lift is measured to be 3.2 kgf. What is the lift coefficient? For a prototype wing of area 10 m2, what is the approximate lift at an air speed of 160 kmph at the same angle of attack of 5°?
Consider an incompressible laminar boundary layer flow over a flat plate of length L, aligned with the direction of an incoming uniform free stream. If F is the ratio of the drag force on the front half of the plate to the drag force on the rear half, then
ln which of the following the friction drag is generally larger than pressure drag?
An airfoil is a streamlined body as shown in the figure below. Because of the streamlining of the body, the separation occurs only at the extreme rear of the body, resulting in

An automobile moving at a velocity of 40 km/hr is experiencing a wind resistance of 2 kN. If the automobile is moving at a velocity of 50 km/hr, the power required to overcome the wind resistance is

Discussion

No Comment Found

Related MCQs

Reply to Comment