A gate in which all the inputs must be low to get a high output is cal – McqOptions

MCQOPTIONS

1.	A gate in which all the inputs must be low to get a high output is called [UPSEAT 2004]
A.	A NAND gate
B.	An inverter
C.	\[2\pi \sqrt{\frac{L}{g}}\]
D.	An AND gate
Answer» C. \[2\pi \sqrt{\frac{L}{g}}\]

Discussion

No Comment Found

Related MCQs

For the diode, the characteristic curves are given at different temperature. The relation between the temperatures is [RPET 1990]
The mutual characteristic curves of a triode are as shown in figure. The cut off voltage for the triode is
The figure represents variation of triode parameter (m or rp or gm) with the plate current. The correct variation of m and rp are given, respectively by the curves
The variation of anode current in a triode corresponding to a change in grid potential at three different values of the plate potential is shown in the diagram. The mutual conductance of the triode is [CPMT 1986, 88]
The given figure shows the wave forms for two inputs A and B and that for the output Y of a logic circuit. The logic circuit is [UPSEAT 2002] (Y)
A gate in which all the inputs must be low to get a high output is called [UPSEAT 2004]
Which logic gate is represented by following diagram [DCE 2001]
Given below are four logic gate symbol (figure). Those for OR, NOR and NAND are respectively [NSEP 1994]
If A and B are two inputs in AND gate, then AND gate has an output of 1 when the values of A and B are [TNPCEE 2002]
How many NAND gates are used to form an AND gate [MP PET 2004]