MCQOPTIONS
Home
About Us
Contact Us
Bookmark
Saved Bookmarks
Testing Subject
General Aptitude
Logical and Verbal Reasoning
English Skills Ability
Technical Programming
Current Affairs
General Knowledge
Finance & Accounting
GATE (Mechanical Engineering)
Chemical Engineering
→
Electrical Engineering
→
Gate (EE) 2018
→
A balanced Wheatstone bridge consists of an of 3,...
1.
A balanced Wheatstone bridge consists of an of 3,500 , an of 200 , and an of 680 . The value of is
A.
680
B.
1,029
C.
200
D.
880
Answer» C. 200
Show Answer
Discussion
No Comment Found
Post Comment
Related MCQs
A 6 V battery output is divided down to obtain two output voltages. Three 2.2 k resistors are used to provide the two taps. The two output voltages are
Two 3.3 k resistors are in series and this series combination is in parallel with a 4.7 k resistor. The voltage across one of the 3.3 k resistors is 12 V. The voltage across the 4.7 k resistor is
A balanced Wheatstone bridge consists of an of 3,500 , an of 200 , and an of 680 . The value of is
In a certain five-step /2 ladder network, the smallest resistor value is 1 k. The largest value is
A 12 k resistor, a 15 k resistor, and a 22 k resistor are in series with two 10 k resistors that are in parallel. The source voltage is 75 V. Current through the 15 k resistor is approximately
The parallel combination of a 470 resistor and a 1.2 k resistor is in series with the parallel combination of three 3 k resistors. A 200 V source is connected across the circuit. The resistor with the most current has a value of
A certain circuit is composed of two parallel resistors. The total resistance is 1,403 . One of the resistors is 2 k. The other resistor value is
The parallel combination of a 470 resistor and a 680 resistor is in series with the parallel combination of four 2 k resistors. The total resistance is
Two 1.2 k resistors are in series and this series combination is in parallel with a 3.3 k resistor. The total resistance is
A certain voltage divider consists of two 12 k resistors in series. Which of the following load resistors will have the most effect on the output voltage?
Reply to Comment
×
Name
*
Email
*
Comment
*
Submit Reply
Your experience on this site will be improved by allowing cookies. Read
Cookie Policy
Reject
Allow cookies