MCQOPTIONS
Saved Bookmarks
MCQOPTIONS
This section includes 10 Mcqs, each offering curated multiple-choice questions to sharpen your Automobile Engineering knowledge and support exam preparation. Choose a topic below to get started.
| 1. |
A two-piece propeller shaft requires one universal joint. |
| A. | True |
| B. | False |
| Answer» C. | |
| 2. |
The axes of the two shafts are intersecting and are at 35 to each other. These two shafts are connected by Hook s joint. At which position of the drives shaft acceleration will be maximum? |
| A. | 68.4 |
| B. | 96.1 |
| C. | 225.5 |
| D. | 330.7 |
| Answer» D. 330.7 | |
| 3. |
What is the need of the universal joint? |
| A. | To change inclination |
| B. | To bend sideways |
| C. | To transfer torque at an angle |
| D. | To change length |
| Answer» D. To change length | |
| 4. |
The axes of the two shafts are intersecting and are at 35 to each other. These two shafts are connected by Hook s joint. At which position of the drives shaft velocity ratio will not be unity? |
| A. | 42.145 |
| B. | 222.145 |
| C. | 317.85 |
| D. | 141.52 |
| Answer» E. | |
| 5. |
Where is the differential located? |
| A. | Between transmission and rear axle |
| B. | Between engine and transmission |
| C. | Between two propeller shaft |
| D. | Between steering wheel and steering column |
| Answer» B. Between engine and transmission | |
| 6. |
The axes of the two shafts are intersecting and are at 30 to each other. These two shafts are connected by Hook s joint. At which position of the drives shaft velocity ratio will be minimum? |
| A. | 90 , 270 |
| B. | 0 , 180 |
| C. | 180 , 270 |
| D. | 90 , 180 |
| Answer» B. 0 , 180 | |
| 7. |
Why do the hypoid gears require special lubricant? |
| A. | Teeth are soft |
| B. | Teeth are hard |
| C. | Gears run faster |
| D. | There is relative motion between teeth |
| Answer» E. | |
| 8. |
Which of the following is the disadvantage of the open differential? |
| A. | High in cost |
| B. | Not reliable |
| C. | Complex design |
| D. | Sends most of the power to the wheel having less traction |
| Answer» E. | |
| 9. |
The axes of the two shafts are intersecting and are at 25 to each other. These two shafts are connected by Hook s joint. At which position of the drives shaft velocity ratio will be maximum? |
| A. | 90 , 270 |
| B. | 0 , 180 |
| C. | 180 , 270 |
| D. | 90 , 180 |
| Answer» C. 180 , 270 | |
| 10. |
Which types of joints are used when the shafts are inclined? |
| A. | Universal joint |
| B. | Hinge joint |
| C. | Ball and socket joint |
| D. | Pivot joint |
| Answer» B. Hinge joint | |