Explore topic-wise MCQs in Engineering Drawing.

This section includes 6 Mcqs, each offering curated multiple-choice questions to sharpen your Engineering Drawing knowledge and support exam preparation. Choose a topic below to get started.

1.

The flat ends of a boiler are prevented from bulging out and are strengthened by means of _________

A. connection of plates at right angles
B. gusset stays
C. welding
D. riveting
Answer» C. welding
Discussion
2.

In butt joint when two straps are used the thickness varies between _______ to ________ (T is the thickness of plate to be connected).

A. T, 1.125T
B. 0.7T, 0.8T
C. 0.5T, T
D. T, 1.5T
Answer» C. 0.5T, T
Discussion
3.

In butt joint when one strap is used the thickness varies between _______ to ________ (T is the thickness of plate to be connected).

A. T, 1.125T
B. 0.7T, 0.8T
C. 0.5T, T
D. T, 1.5T
Answer» B. 0.7T, 0.8T
Discussion
4.

In zigzag lap joint formation when P is the pitch between the rivets, the distance between the rows of rivets should not be less than _____

A. 0.6P
B. 0.8P
C. P
D. 1.2P
Answer» B. 0.8P
Discussion
5.

Width (L) of overlap of sheets is equal to ________ when d is the diameter of a rivet in case of single-riveted lap joint.

A. 2d
B. 3d
C. 4d
D. 5d
Answer» C. 4d
Discussion
6.

What type of failure will occur when rivets are smaller than necessary?

A. Tearing of plate between the holes
B. Tearing of plate between the edges
C. Shearing of rivet
D. Crushing of plate
Answer» D. Crushing of plate
Discussion