Explore topic-wise MCQs in Engineering.

This section includes 9294 Mcqs, each offering curated multiple-choice questions to sharpen your Engineering knowledge and support exam preparation. Choose a topic below to get started.

7701.

In the wheatstone bridge in figure, each resistance is increased by 0.05%. The value of v0 will be

A. 50 mV
B. 5 mV
C. 0.1 mV
D. zero
Answer» E.
7702.

Consider the following Statements regarding resistance strain gauge The gauge factor is in the range of 2 to 5.The resistance changes due to change in specific resistance with strain.The resistance increases with increase in temperature. Of the above statements, which are correct?

A. 1, 2, 3
B. 1 and 2
C. 2 and 3
D. 1 and 3
Answer» E.
7703.

PCM employing 4 bit code is used to send data having frequency range from 0 to 2 kHz. The minimum required bandwidth of carrier channel is

A. 2 kHz
B. 4 kHz
C. 8 kHz
D. 16 kHz
Answer» C. 8 kHz
7704.

A sinusoidal ac voltage of amplitude 100 V is applied to a rectifying device which offers 10 Ω resistance in forward direction and infinite resistance in reverse direction. The reading on hot wire ammeter will be

A. 10 A
B. 5 A
C. 3.185 A
D. 1.414 A
Answer» C. 3.185 A
7705.

When a capacitor is connected to the terminals of an ohmmeter, the pointer indicated a low resistance initially and finally come to infinity position. This shows that capacitor is

A. short circuited
B. all right
C. faulty
D. open circuited
Answer» C. faulty
7706.

In an induction wattmeter, the shading bands are made of non conducting material.

A. True
B. False
Answer» C.
7707.

In the balanced bridge shown in figure. X should be

A. a self inductance having resistance
B. a capacitance
C. a non-inductive resistance
D. an inductance and capacitance in parallel
Answer» B. a capacitance
7708.

If the current in a capacitor leads the voltage by 80 , the loss angle of capacitor is

A. 80
B. 10
C. 100
D. 170
Answer» C. 100
7709.

The lowest frequency used in satellite communications is __________ GHz.

A. 0.8
B. 3
C. 18
D. 30
Answer» B. 3
7710.

The average noise temperature of Earth, as viewed from space, is __________ K.

A. 254
B. 303
C. 100
D. 500
Answer» B. 303
7711.

Geosynchronous communication satellites travel around the earth in circular orbits with a forward speed of about __________ km/h.

A. 11200
B. 0
C. 36000
D. 22800
Answer» B. 0
7712.

In satellite communication, highly directional antennas are used to

A. direct the spot beam to a particular region of space on Earth
B. strengthen the beam to overcome the cosmic noise
C. make corrections in change of polarisation of the beam
D. select a particular channel in transmission and reception
Answer» B. strengthen the beam to overcome the cosmic noise
7713.

System satellites orbit the Earth once in

A. 24 hours
B. 12 hours
C. 1 hours
D. 6 hours
Answer» B. 12 hours
7714.

Low-orbit satellites are not used for communications because they

A. produce sonic booms
B. do not provide 24 hour/ day contact to the users on Earth
C. heat up and melt
D. none
Answer» D. none
7715.

A few minutes disturbance in space communications occurs twice a year during Sunblinding when __________ are in line.

A. Sun and satellite
B. Sun and Earth station
C. Satellite and Earth station
D. Sun, satellite and Earth station
Answer» E.
7716.

After the death of INSAT-IB, the mainstay of the entire Indian satellite network for some time to come would be

A. INSTELSAT-V
B. INSAT-ID
C. INSAT-2
D. ARABSAT
Answer» E.
7717.

For satellite transmission, analog signals may be converted into digital form with the help of

A. modem
B. transponder
C. codec
D. compandor
Answer» D. compandor
7718.

Geosynchronous satellites are always launched in the equatorial plane because it is the only plane which provides

A. 24-hour orbit
B. stationary satellite
C. global communication
D. zero-gravity environs
Answer» D. zero-gravity environs
7719.

The maximum signal propagation time of a geosynchronous satellite transmission is about __________ millisecond.

A. 540
B. 270
C. 135
D. 1080
Answer» C. 135
7720.

Ferrites have

A. a low copper loss
B. low eddy current loss
C. low resistivity
D. higher specific gravity compared to iron
Answer» C. low resistivity
7721.

Assertion (A): Diamond and carborudum are both very hard materials.Reason (R): Valence band can be extremely strong.

A. Both A and R are true and R is correct explanation of A
B. Both A and R are true but R is not correct explanation of A
C. A is true but R is false
D. A is false but R is true
Answer» B. Both A and R are true but R is not correct explanation of A
7722.

Nichrome is used for

A. overload line wires
B. heater coils
C. lamp filaments
D. all of the above
Answer» C. lamp filaments
7723.

The chemical properties of atoms are determined by all the electrons and their configuration.

A. True
B. False
Answer» C.
7724.

Assertion (A): Hall effect is used to determine whether the semi- conductor is p or n type.Reason (R): Under the influence of field, holes and electrons move in opposite direction.

A. Both A and R are true and R is correct explanation of A
B. Both A and R are true but R is not correct explanation of A
C. A is true but R is false
D. A is false but R is true
Answer» B. Both A and R are true but R is not correct explanation of A
7725.

The number of protons in a silicon atom are

A. 4
B. 8
C. 12
D. 14
Answer» E.
7726.

The fact that domains exhibits spontaneous magnetisation is

A. first hypothesis is of Curie
B. second hypothesis is of Weiss
C. Curie-Weiss law
D. Boltzmann's statistics
Answer» C. Curie-Weiss law
7727.

Kelvin's double bridge is used to measure low resistances because

A. it has high sensitivity
B. there is no thermoelectric emf
C. resistance variation due to temperature
D. effect of contact and lead resistances is eliminated
Answer» E.
7728.

Assertion (A): Shunt of an ammeter has a low resistance.Reason (R): Shunt may be connected in series or in parallel with ammeter.

A. Both A and R are true and R is correct explanation of A
B. Both A and R are true but R is not correct explanation of A
C. A is true R is false
D. A is false R is true
Answer» D. A is false R is true
7729.

The scale of hot wire instrument is linear.

A. True
B. False
Answer» C.
7730.

Consider the following galvanometers D'ArsonvalBallisticVibration Which of these are permanent magnet moving coil instruments?

A. 1 and 2 only
B. 1, 2 and 3
C. 2 and 3 only
D. 1 and 3 only
Answer» C. 2 and 3 only
7731.

The output of a Piezoelectric crystal has

A. low amplitude and low impedance
B. high amplitude and low impedance
C. low amplitude and high impedance
D. high amplitude and high impedance
Answer» D. high amplitude and high impedance
7732.

A universal RLC bridge uses

A. Maxwell bridge for measurement of inductance and De Sauty's bridge for measurement of capacitance
B. Maxwell's bridge for measurement of inductance and modified De Sauty bridge for measurement of capacitance
C. Maxwell Wien bridge for measurement of inductance and modified De Sauty bridge for measurement of inductance
D. Maxwell Wien bridge for measurement of inductance and Wien bridge for measurement of capacitance
Answer» D. Maxwell Wien bridge for measurement of inductance and Wien bridge for measurement of capacitance
7733.

A single phase energy meter operates on induction principle.

A. True
B. False
Answer» B. False
7734.

The accuracy of measurement using CRO is about

A. 0.5%
B. 0.05 %
C. 1%
D. 3%
Answer» E.
7735.

In body centred cubic structure, comers and centre of the cube are occupied by identical atoms.

A. True
B. False
Answer» B. False
7736.

A dielectric is subjected to alternating field. The dielectric losses are potential to

A. real part of dielectric constant
B. imaginary part of dielectric constant
C. both real and imaginary parts of dielectric constant
D. either real or imaginary part of dielectric constant
Answer» C. both real and imaginary parts of dielectric constant
7737.

Assertion (A): Dielectric losses are proportional to tan .Reason (R): tan = where r' and r" denote the real and imaginary parts of r.

A. Both A and R are true and R is correct explanation of A
B. Both A and R are true but R is not correct explanation of A
C. A is true but R is false
D. A is false but R is true
Answer» B. Both A and R are true but R is not correct explanation of A
7738.

Inductors used at V.H.F. are made using

A. air core
B. cast iron cored
C. sheet steel cored
D. thin film technique
Answer» E.
7739.

The noise temperature of sky is about __________ K.

A. 100
B. 273
C. 0
D. 30
Answer» E.
7740.

The units for electric dipole moment are

A. coulombs
B. colomb-metre
C. coulomb/metre
D. coulomb/m
E. <sup>2</sup>
Answer» C. coulomb/metre
7741.

Assertion (A): The equation D = 0 rE is applicable only to isotropic materials.Reason (R): In polycrystalline materials, the directional effects are absent.

A. Both A and R are true and R is correct explanation of A
B. Both A and R are true but R is not correct explanation of A
C. A is true but R is false
D. A is false but R is true
Answer» C. A is true but R is false
7742.

When an electron moves at velocity v in combined electric and magnetic fields E and H, the Lorentz force F is F = - e(E + v x B).

A. True
B. False
Answer» B. False
7743.

Assertion (A): Holes are majority carriers in p type semiconductor.Reason (R): In p type semiconductor, the electrons produced by thermal agitation recombine with holes.

A. Both A and R are true and R is correct explanation of A
B. Both A and R are true but R is not correct explanation of A
C. A is true but R is false
D. A is false but R is true
Answer» B. Both A and R are true but R is not correct explanation of A
7744.

Assertion (A): Dielectric constant is independent of temperature unless the temperature is extremely high.Reason (R): For normal temperatures the number of atoms per unit volume is constant.

A. Both A and R are true and R is correct explanation of A
B. Both A and R are true but R is not correct explanation of A
C. A is true but R is false
D. A is false but R is true
Answer» B. Both A and R are true but R is not correct explanation of A
7745.

The temperature at which some materials become superconductors is called

A. Transition temperature
B. Curie temperature
C. Neel temperature
D. Onnes temperature
Answer» B. Curie temperature
7746.

Wheatstone bridge is suitable for low resistances.

A. True
B. False
Answer» C.
7747.

In an homogeneous dielectric subjected to an electric field E, the dipole moment per unit volume is 0( r - 1) E.

A. True
B. False
Answer» B. False
7748.

Which of the following is not correct in respect of electrostatic instrument?

A. It is essentially a voltmeter
B. It is suitable for only high voltages
C. It has a uniform scale
D. It can be used for both ac and dc
Answer» D. It can be used for both ac and dc
7749.

Two resistance R1 and R2 are connected in series R1 = 528 5 &amp;ohm; and R2 = 325 3&amp;ohm;. The total resistance will be

A. 853 2 &ohm;
B. 853 5 &ohm;
C. 853 3 &ohm;
D. 853 8 &ohm;
Answer» E.
7750.

If A = 131 4 and B = 106 4, the percentage range of doubt in A - B is

A. 4%
B. 8%
C. 16%
D. 32%
Answer» E.