MCQOPTIONS
Saved Bookmarks
MCQOPTIONS
This section includes 13 Mcqs, each offering curated multiple-choice questions to sharpen your Engineering Drawing knowledge and support exam preparation. Choose a topic below to get started.
| 1. |
The Grade becomes ______ according to the figure placed in front of the letter B, 2B, 3B, 4B etc. |
| A. | harder |
| B. | lighter |
| C. | darker |
| D. | softer |
| Answer» E. | |
| 2. |
What is the next size of 210 mm x 297 mm in drawing papers? |
| A. | 148 mm x 210 mm |
| B. | 297 mm x 420 mm |
| C. | 420 mm x 594 mm |
| D. | 105 mm x 148 mm |
| Answer» C. 420 mm x 594 mm | |
| 3. |
The increase in hardness is shown by the value of the figure put in front of the letter H, 2H, 3H, and 4H etc. |
| A. | True |
| B. | False |
| Answer» B. False | |
| 4. |
The sizes from A0 to A5 increases. |
| A. | True |
| B. | False |
| Answer» C. | |
| 5. |
The areas of the two subsequent sizes of drawing sheet are in the ratio ____ |
| A. | 1:5 |
| B. | 1:4 |
| C. | 1:2 |
| D. | 1:10 |
| Answer» D. 1:10 | |
| 6. |
_________ is used to draw curves which are not circular. |
| A. | Compass |
| B. | Protractor |
| C. | French curves |
| D. | Pro circle |
| Answer» D. Pro circle | |
| 7. |
The cardboard scales are available in a set of _______ scales. |
| A. | six |
| B. | ten |
| C. | eight |
| D. | twelve |
| Answer» D. twelve | |
| 8. |
Which is not the use of divider? |
| A. | To divide curved or straight lines into the desired number of equal parts |
| B. | To draw circles |
| C. | To transfer dimensions from one part of the drawing to another part |
| D. | To set-off given distances from the scale to the drawing |
| Answer» C. To transfer dimensions from one part of the drawing to another part | |
| 9. |
Small bow compass can draw circles less than _____ mm radius. |
| A. | 25mm |
| B. | 30mm |
| C. | 35mm |
| D. | 40mm |
| Answer» B. 30mm | |
| 10. |
The angle which we can’t make using both the Set-squares is _____________ |
| A. | 15o |
| B. | 105o |
| C. | 165o |
| D. | 125o |
| Answer» E. | |
| 11. |
The angle which we can’t make using a single Set-square is ________ |
| A. | 45o |
| B. | 60o |
| C. | 30o |
| D. | 75o |
| Answer» E. | |
| 12. |
The part that doesn’t belong to T-square is __________ |
| A. | Working edge |
| B. | Blade |
| C. | Stock |
| D. | Ebony |
| Answer» E. | |
| 13. |
How many battens will be there for a Drawing board? |
| A. | 1 |
| B. | 2 |
| C. | 3 |
| D. | 4 |
| Answer» C. 3 | |