Explore topic-wise MCQs in Technical Programming.

This section includes 1088 Mcqs, each offering curated multiple-choice questions to sharpen your Technical Programming knowledge and support exam preparation. Choose a topic below to get started.

751.

When the time to establish link is large and the size of data is small, the preferred mode of data transfer is

A. Circuit switching
B. Packet switching
C. Time division multiplexing
D. All of the above
Answer» C. Time division multiplexing
752.

Which of the following bus types are used by the Apple Macintosh computer?

A. ISA
B. NuBus
C. EISA
D. MCA
Answer» C. EISA
753.

Which of the following memories contains a thin film of magnetic material sandwitched between two permanent bias magnets?

A. ROM
B. Magnetic disk
C. Core memory
D. Bubble memory
Answer» D. Bubble memory
754.

An integrated circuit is

A. a complicated circuit
B. an integrating device
C. much costlier than a single transistor
D. fabricated on a tiny silicon chip
Answer» E.
755.

What is the highest address possible if 16 bits are used for each address?

A. 65536
B. 12868
C. 16556
D. 643897
Answer» B. 12868
756.

A single bus structure is primarily found in

A. Main frames
B. Super computers
C. High performance machines
D. Mini-and micro-computers
Answer» E.
757.

In a punched card system, data is processed by a

A. keypunch machine, sorter, and posting machine
B. accounting machine, posting machine, and billing machine
C. sorter, posting machine, and billing machine
D. accounting machine, keypunch machine, and sorter
Answer» E.
758.

The monitor of a computer is connected to it by a

A. Wire
B. Cable
C. Bus
D. Line driver
Answer» C. Bus
759.

When did IBM close the last of its punched card manufacturing plant?

A. June, 1989
B. December, 1984
C. March, 1982
D. March, 1982
Answer» C. March, 1982
760.

Accessing records from a file directly without searching from the beginning of the file is

A. Time sharing
B. Random
C. Direct access
D. Access time
Answer» D. Access time
761.

Which of the following best describes a computer-based information system?

A. A system in which a computer is used to turn data into information
B. Inputting data
C. Processing data
D. Performing complex mathematical calculations
Answer» B. Inputting data
762.

The CPU chip used in a computer is partially made out of

A. silica
B. carbon
C. copper
D. gold
Answer» B. carbon
763.

The term gigabyte refers to

A. 1024 bytes
B. 1024 kilobytes
C. 1024 megabytes
D. 1024 gigabytes
Answer» D. 1024 gigabytes
764.

In which addressing mode, the effective address of the operand is generated by adding a constant value to the contents of a register?

A. Absolute mode
B. Indirect mode
C. Immediate mode
D. Index mode
Answer» E.
765.

The equipment with which the computer talks to its users is called a

A. word processor
B. peripheral
C. software
D. diskette
Answer» C. software
766.

A printed document reader which scans the characters and then encodes them in a computer-compatible code for direct transmission to the computer is called

A. Optical character reader
B. Kurzweil Data Entry Machine (KDEM)
C. MICR
D. Laser scanner
Answer» C. MICR
767.

A high quality CAD system uses the following for printing drawing and graphs

A. Dot matrix printer
B. Digital plotter
C. Line printer
D. All of the above
Answer» C. Line printer
768.

The output of a 2 input OR gate is 0 only when its

A. both inputs are 0
B. either input is 1
C. both inputs are 1
D. either input is 0
Answer» B. either input is 1
769.

What type of computer programming is used for airplane ticket reservation system?

A. Multi programming
B. Real time programming
C. Time sharing
D. Batch programming
Answer» C. Time sharing
770.

Who coordinates the sequencing of events within the central processor of a computer?

A. Logic unit
B. Arithmetic unit
C. Register
D. Control unit
Answer» E.
771.

Which term is not used to describe the memory component of a computer?

A. ROM
B. PROM
C. RAM
D. SAM
Answer» E.
772.

Personal computers use a number of chips mounted on a main circuit board. What is the common name for such boards?

A. Daughterboard
B. Motherboard
C. Fatherboard
D. Breadboard
Answer» C. Fatherboard
773.

The data recording area between the blank gaps on magnetic tape is called a/ an:

A. Record
B. Block
C. Field
D. Database
Answer» C. Field
774.

In magnetic disks, data is organized on the platter in a concentric sets of rings called

A. sector
B. track
C. head
D. block
Answer» C. head
775.

Microfilm reader is a

A. OCR device
B. COM device
C. MICR device
D. None of the above
Answer» C. MICR device
776.

Conversion of hexadecimal number 1D7F16 to a decimal number is

A. 755110
B. 877110
C. 555710
D. 778110
Answer» B. 877110
777.

Magnetic tape can serve as :

A. secondary-storage media
B. output media
C. input media
D. All of the above
Answer» E.
778.

What is meant by the term RAM?

A. Memory which can only be read
B. Memory which can be both^read and written to
C. Memory which is used for permanent storage
D. Memory which can only be written to
Answer» C. Memory which is used for permanent storage
779.

What technology is used for flat panel displays?

A. Solid state
B. RBG monitor
C. VLSI
D. Direct view storage tube
Answer» B. RBG monitor
780.

What is the name given to the 8-bit unit used for coding data?

A. block of characters
B. byte
C. word
D. None of the above
Answer» C. word
781.

Which of the following professions has not been affected by personal computers?

A. medical
B. clerical
C. accounting
D. None of the above
Answer» E.
782.

The Santa Clara Valley, California is popularly known as Silicon Valley of America because

A. huge deposits of silicon are found there
B. many silicon chip manufacturing firms are located there
C. Santa Claus visits it every Christmas
D. it is full of large grain sand
Answer» C. Santa Claus visits it every Christmas
783.

A double sided magnetic disk pack has six disks. Can you tell how many surfaces of this pack are normally used?

A. 10
B. 12
C. 6
D. 9
Answer» B. 12
784.

When was the X Window System born?

A. 1984
B. 1989
C. 1988
D. 1990
Answer» B. 1989
785.

Who developed the first personal computer spreadsheet package called Visicalc?

A. Niklaus Wirth
B. Dan Bricklin
C. Bob Frankston
D. both (b) and (c)
Answer» E.
786.

The microelectronics is the technology of

A. microwaves
B. microcomputers
C. chips
D. automatic processing
Answer» D. automatic processing
787.

The first microprocessor built by the Intel Corpn. was called

A. 8008
B. 8080
C. 4004
D. 8800
Answer» D. 8800
788.

Which of the following typically uses a keyboard for input?

A. desktop terminal
B. point-of-sale terminal
C. financial transaction terminal
D. All of the above
Answer» E.
789.

The general range of speed in revolutions per minute (rpm) at which floppy disks rotate is

A. 2400-4700
B. 390-600
C. 150-250
D. 300-600
Answer» D. 300-600
790.

The terminal device that functions as a cash register, computer terminal, and OCR reader is the:

A. Data collection terminal
B. OCR register terminal
C. Video display terminal
D. POS terminal
Answer» E.
791.

Different components on the motherboard of a PC processor unit are linked together by sets of parallel electrical conducting lines. What are these lines called?

A. Conductors
B. Buses
C. Connectors
D. Connectively
Answer» C. Connectors
792.

Which memory system is not as a mass memory medium?

A. semiconductor memory
B. magnetic tape
C. magnetic disk
D. magnetic drum
Answer» B. magnetic tape
793.

A type of line printer that uses an embossed steel band to form the letters printed on the paper is

A. Golf ball printer
B. Dot-matrix printer
C. Laser printer
D. Band printer
Answer» E.
794.

A processing unit that coordinates networks and data communication is known as

A. Control unit
B. Communications processor
C. Register unit
D. CPU
Answer» C. Register unit
795.

The barcode which is used on all types of items, is read by a scanning device directly into the computer. What is the name of this scanning device?

A. Laser scanner
B. Wand
C. OCR
D. MICR
Answer» B. Wand
796.

A 'number crunching' computer is one that can handle

A. large spreadsheets
B. large alphanumeric data
C. large volume of numbers
D. only numbers
Answer» D. only numbers
797.

The computer program language which is widely used in computer science and engineering and also in business is

A. COBOL
B. FORTRAN
C. PASCAL
D. LISP
Answer» D. LISP
798.

When did Hewlett-Packard Inc. Introduce its first HP-110 laptop computer?

A. 1984
B. 1986
C. 1990
D. 1995
Answer» B. 1986
799.

Who was the father of Punched Card Processing?

A. J Presper Eckert
B. Charles Babbage
C. Dr. Herman Hollerith
D. Blaise Pascal
Answer» D. Blaise Pascal
800.

ENIAC (Electronic Numerical Integrator and Calculator) had huge advantage over Mark I because it used electronic valves in place of the electromagnetic switches. In the beginning, ENIAC was used for calculating the path of artillery shells. For which other was weapon design was it utilized?

A. hydrogen bomb
B. atom bomb
C. agnimissile
D. fighter aircraft
Answer» B. atom bomb