MCQOPTIONS
Saved Bookmarks
MCQOPTIONS
This section includes 11 Mcqs, each offering curated multiple-choice questions to sharpen your Electrical Measurements knowledge and support exam preparation. Choose a topic below to get started.
| 1. |
Electrical continuity between any two points exists if _________ |
| A. | there is current flow through them |
| B. | there is a wire connecting the points |
| C. | there is sufficient voltage drop |
| D. | pointer shows deflection |
| Answer» E. | |
| 2. |
Continuity between any two points can be measured using _________ |
| A. | ammeter |
| B. | voltmeter |
| C. | megger |
| D. | galvanometer |
| Answer» D. galvanometer | |
| 3. |
Megger can be used for verifying the electrical insulation level of ____________ |
| A. | passive components such as resistance, capacitor and inductance |
| B. | devices such as motor, cable, etc |
| C. | solid state devices |
| D. | liquid crystal devices |
| Answer» C. solid state devices | |
| 4. |
How is the megger calibrated? |
| A. | in steps of 1 unit per division |
| B. | based on the value of resistance to be measured |
| C. | directly calibrated on the position of the pointer |
| D. | reversely calibrated based on the pointer position |
| Answer» E. | |
| 5. |
What is the significance of a megger with respect to high resistance? |
| A. | it is used to limit the current |
| B. | it is used to provide stability |
| C. | used for measuring high resistance with respect to ground |
| D. | it is used for temperature protection |
| Answer» D. it is used for temperature protection | |
| 6. |
The application of a megger is _________ |
| A. | to measure resistance |
| B. | to test for leakage |
| C. | to limit the current |
| D. | to increase the emf of the circuit |
| Answer» C. to limit the current | |
| 7. |
Megger is also known as _________ |
| A. | megaohmmeter |
| B. | multimeter |
| C. | galvanometer |
| D. | ammeter |
| Answer» B. multimeter | |
| 8. |
Electrical continuity between any two points exists if |
| A. | there is current flow through them |
| B. | there is a wire connecting the points |
| C. | there is sufficient voltage drop |
| D. | pointer shows deflection |
| Answer» E. | |
| 9. |
Continuity between any two points can be measured using |
| A. | ammeter |
| B. | voltmeter |
| C. | megger |
| D. | galvanometer |
| Answer» D. galvanometer | |
| 10. |
Megger can be used for verifying the electrical insulation level of |
| A. | passive components such as resistance, capacitor and inductance |
| B. | devices such as motor, cable, etc |
| C. | solid state devices |
| D. | liquid crystal devices |
| Answer» C. solid state devices | |
| 11. |
Why is the scale of a megger calibrated in megaohms? |
| A. | to indicate resistance |
| B. | to minimise the current flow |
| C. | to increase the voltage drop |
| D. | to reduce the temperature |
| Answer» B. to minimise the current flow | |