MCQOPTIONS
Saved Bookmarks
MCQOPTIONS
This section includes 12 Mcqs, each offering curated multiple-choice questions to sharpen your Casting knowledge and support exam preparation. Choose a topic below to get started.
| 1. |
Which of the following is the main drawback of using the shell mould casting method? |
| A. | Limited size of casting parts |
| B. | High cost |
| C. | Rough surface finish |
| D. | Slow rate production |
| Answer» B. High cost | |
| 2. |
Which of the following is the drawback of using the sand casting process? |
| A. | Limited alloys |
| B. | Expensive mould |
| C. | Uneconomical for low quantities |
| D. | Labour intensive |
| Answer» E. | |
| 3. |
WHICH_OF_THE_FOLLOWING_IS_THE_DRAWBACK_OF_USING_THE_SAND_CASTING_PROCESS??$ |
| A. | Limited alloys |
| B. | Expensive mould |
| C. | Uneconomical for low quantities |
| D. | Labour intensive |
| Answer» E. | |
| 4. |
Which of the following is the main drawback of using the shell mould casting method?$ |
| A. | Limited size of casting parts |
| B. | High cost |
| C. | Rough surface finish |
| D. | Slow rate production |
| Answer» B. High cost | |
| 5. |
Which of the following is the main disadvantage of using the hot chamber die casting process? |
| A. | High tooling cost |
| B. | Slow production rate |
| C. | Rough surface finish |
| D. | Not economical for large scale production |
| Answer» B. Slow production rate | |
| 6. |
Which of the following is the main advantage of using the centrifugal casting method? |
| A. | Defects less casting |
| B. | Maximum casting yield |
| C. | Low cost |
| D. | Fast production of castings |
| Answer» C. Low cost | |
| 7. |
Large volume casting with great segregation is the main advantage of using the squeeze casting method. |
| A. | True |
| B. | False |
| Answer» C. | |
| 8. |
Which of the following is not the advantage of using the permanent mould casting method? |
| A. | Mould can be used again and again |
| B. | Good thermal conductivity of mould |
| C. | Very complex shapes of casting can be produced |
| D. | Low cost process |
| Answer» D. Low cost process | |
| 9. |
Which of the following is the drawback of using the low-pressure die casting technique? |
| A. | Material loss |
| B. | Time consuming |
| C. | Much labour work |
| D. | Uneconomical for small scale production |
| Answer» E. | |
| 10. |
In slush casting method, negligible metal loss is the main advantage during the casting process. |
| A. | True |
| B. | False |
| Answer» B. False | |
| 11. |
Expensive moulding process is the major disadvantage of using the sand casting process. |
| A. | True |
| B. | False |
| Answer» C. | |
| 12. |
Which of the following is the main advantage of using investment casting method? |
| A. | Better quality |
| B. | Low cost |
| C. | Complex shapes |
| D. | Reusable mould |
| Answer» D. Reusable mould | |