Which principle is related to Gauge design? – McqOptions

MCQOPTIONS

1.	Which principle is related to Gauge design?
A.	Rankin principle
B.	Position principle
C.	Taylor‚Äö√Ñ√∂‚àö√ë‚àö¬•s principle
D.	Carnot Principle
Answer» D. Carnot Principle

Discussion

No Comment Found

Related MCQs

If work tolerance is less than 0.09 mm then how much wear tolerance is applied to ‘Go’ gauge?
Which of the following option is correct for the given statements about Gauge design?Statement 1: ‘No Go’ gauges should put in the condition of maximum impassability in the inspection.Statement 2: ‘Go’ plug gauge corresponds to a minimum limit.
Which deviations are provided to a new ‘Go’ plug gauge from the nominal size?
What is the use of ‘No Go’ gauges?
What is the effect of wear on the size of ‘Go’ snap gauges?
Which of the following can’t be done by ‘Go’ plug gauges?
‘Go limit’ applied to which limit condition?
If_work_tolerance_is_less_than_0.09_mm_then_how_much_wear_tolerance_is_applied_to_‚Äö√Ñ√∂‚àö√ë‚àö‚â§Go‚Äö√Ñ√∂‚àö√ë‚àö¬•_gauge?$#
Which deviations are provided to a new ‚Äö√Ñ√∂‚àö√ë‚àö‚â§Go‚Äö√Ñ√∂‚àö√ë‚àö¬• plug gauge from the nominal size?#
What is the use of ‚Äö√Ñ√∂‚àö√ë‚àö‚â§No Go‚Äö√Ñ√∂‚àö√ë‚àö¬• gauges?$