When is a capacitor fully charged? – McqOptions

MCQOPTIONS

1.	When is a capacitor fully charged?
A.	when the voltage across its plates is of the voltage from ground to one of its plates
B.	when the current through the capacitor is the same as when the capacitor is discharged
C.	when the voltage across the plates is 0.707 of the input voltage
D.	when the current through the capacitor is directly proportional to the area of the plates
Answer» C. when the voltage across the plates is 0.707 of the input voltage

Discussion

No Comment Found

Related MCQs

If a current of 40 mA flows through a series circuit consisting of a 0.4 F capacitor and a resistor in series with a 4 kHz, 40 V source, what is the total circuit impedance?
If C, a 4.7 F capacitor, and C, a 3.3 F capacitor are in series with 18 V applied, what is the voltage across C?
What is the impedance of a series RC circuit that consists of a 0.22 F capacitor and a 200-ohm resistor connected to a 3 kHz source?
In a 20 V series RC circuit, if 20 V is measured across the resistor and 40 V is measured across the capacitor, the applied voltage is:
What is the angle theta value for a 5.6 F capacitor and a 50-ohm resistor in series with a 1.1 kHz, 5 V source?
When a 4.7 F capacitor is connected to a 1 kHz source, what is its capacitive reactance?
You could increase the time constant of an circuit by
The phase angle of an RC series circuit is = invtan (X/R) = invtan (V/V).
The true power in an RC series circuit is P = I x R.
With a 500 kHz signal source, what would be the value of a capacitor yielding a capacitive reactance of 1 k ?