What will be the design load for bridges and culverts on National High – McqOptions

MCQOPTIONS

1.	What will be the design load for bridges and culverts on National Highway?
A.	I.R.C. Class-D loading
B.	I.R.C. Class-C loading
C.	I.R.C. Class-A loading
D.	I.R.C. Class-B loading
Answer» D. I.R.C. Class-B loading

Discussion

No Comment Found

Related MCQs

If subgrade is soft or weak, a thick sub-base of cheap and inferior materials well compacted should be used.
Inter coat shall be of stone ballast, or over burnt brick ballast of 50cm thick layer and consolidated and compacted by road roller to 0.8 cm.
What will be the ruling gradient in hills on “Other district roads”?
INTER_COAT_SHALL_BE_OF_STONE_BALLAST,_OR_OVER_BURNT_BRICK_BALLAST_OF_50CM_THICK_LAYER_AND_CONSOLIDATED_AND_COMPACTED_BY_ROAD_ROLLER_TO_0.8_CM.?$
If subgrade is soft or weak, a thick sub-base of cheap and inferior materials well compacted should be used.$
First_coat_of_bituminous_painting_shall_be_with_stone_ballast_no.3_and_stone_grit_of_20_mm_gauge_at_220_kg_of_asphalt_and_1.35_cu_m_of_stone_grit_per_100_sq._m.$
Which authority is responsible for national highway?
As soon as sufficient length of premix has been laid, rolling should be started with 2 to 4 tonne roller.
Stone grits used for 1st coat and 2nd surface painting may be precoated in advance with advance with bitumen.
Laying and consolidation shall be done during dry season.