The same signal in Problem 2 is applied to an RC high-pass filter. If – McqOptions

MCQOPTIONS

1.	The same signal in Problem 2 is applied to an RC high-pass filter. If the reactance is zero at the input frequency, the output voltage is
A.	18 V peak-to-peak
B.	zero
C.	9 V peak-to-peak
D.	12.73 V peak-to-peak
Answer» B. zero

Discussion

No Comment Found

Related MCQs

In an low-pass filter, the output voltage is taken across the resistor and the output lags the input voltage.
An low-pass filter consists of a 5.6 mH coil and a 3.3 k resistor. The output voltage is taken across the resistor. The circuit's critical frequency is
In a series resonant band-pass filter, a lower value of results in
A parallel resonant band-pass filter consists of a 90 resistor in series with a parallel network made up of a 60 mH coil and a 0.02 F capacitor. The output is taken across the capacitor/coil. The coil winding has a resistance of 20 . What is the center frequency of the filter?
A band-pass filter rejects all frequencies within a band between a lower and an upper critical frequency and passes all others.
A band-stop filter passes frequencies between its lower and upper critical frequencies and rejects all others.
The output voltage is 63.3% of its maximum at the critical frequencies.
In an high-pass filter, the output is taken across the inductor and the output leads the input.
In an high-pass filter, the output is taken across the resistor and the output leads the input.
The bandwidth of a resonant filter is determined by the quality factor () of the circuit and the resonant frequency.