MCQOPTIONS
Home
About Us
Contact Us
Bookmark
Saved Bookmarks
Testing Subject
General Aptitude
Logical and Verbal Reasoning
English Skills Ability
Technical Programming
Current Affairs
General Knowledge
Finance & Accounting
GATE (Mechanical Engineering)
Chemical Engineering
→
Control System
→
Effect Adding Zero System Ii
→
The open-loop DC gain of a unity negative feedback...
1.
The open-loop DC gain of a unity negative feedback system with closed-loop transfer function
A.
9 / 4
B.
1 / 9
C.
4 / 5
D.
4 / 9
Answer» E.
Show Answer
Discussion
No Comment Found
Post Comment
Related MCQs
For the transfer functionG(s) = 5(s + 4) s (s + 0.25)(s2 + 4s + 25)The values of the constant gain term and the highest corner frequency of t he Bode plot respectively are
The maximum phase shift that can be provided by a lead compensator with transfer functionG(s) = 1 + 6s is1 + 2s
A linear second-order single-input continuous-time system is described by the following set of differential equations : X1 (t) = 2 X1 (t) + 4 X2 (t) X2 (t) = 2 X1 (t) X2 (t) + u (t) where X1 (t) and X2 (t) are the state variables and u (t) is the control variable. The system is
A system with the open loop transfer function G(s) = K s(s + 2)(s2 + 2s + 2)is connected in a negative feedback configuration with a feedback gain of unity. For the closed loop system to be marginally stable, the value of K is ____
The closed-loop transfer function of a system is T(s) = 4 (s2 + 0.4s + 4)The steady state error due to unit step input is ____.
An open loop control system results in a response of e 2t (sin5t + cos5t) for a unit impulse input. The DC gain of the control system is ______.
For the transfer functionG(s) H(s) = 1 s (s + 1)(s + 0.5)the phase cross-over frequency is_____ rad/sec
The value of k for a unity feedback system with G(s) = k s(1 + s)to have a peak overshoot of 50% is _______
The z-transform of a signal is given by c(z) = z 1 (1 - z 4)4(1 - z 1)2Its final value is_______ .
A unity-feedback control system has the open-loop transfer functionG(s) = 4(1 + 2s) s2 (s + 2)If input to the system is a unit ramp, then steadystate error will be_______
Reply to Comment
×
Name
*
Email
*
Comment
*
Submit Reply
Your experience on this site will be improved by allowing cookies. Read
Cookie Policy
Reject
Allow cookies