The asynchronous inputs are normally labeled ________ and ________, an – McqOptions

MCQOPTIONS

1.	The asynchronous inputs are normally labeled ________ and ________, and are normally active-________ inputs.
A.	PRE, CLR, LOW
B.	ON, OFF, HIGH
C.	START, STOP, LOW
D.	SET, RESET, HIGH
Answer» B. ON, OFF, HIGH

Discussion

No Comment Found

Related MCQs

An active-HIGH input S-R latch has a 1 on the S input and a 0 on the R input. What state is the latch in?
Assume an latch, made from cross-coupled NAND gates, has a 0 on both inputs. The outputs will be ________.
A flip-flop operation is described as a toggle when the result after a clock is ________.
The term hold always means ________.
A retriggerable one-shot has a pulse width of 10 ms; 3 ms after being triggered, another trigger pulse is applied. The resulting output pulse will be ________ mS.
ICs can perform sequential operations, including counting and data shifting.
The major advantage of a Schmitt trigger input is that it ________.
The point(s) on this timing diagram where the Q output of a D latch will be HIGH is/are ________.
The advantage of a J-K flip-flop over an S-R FF is that ________.
The J-K flip-flop is a standard building block of clocked (sequential) logic circuits known as logic standard primitives.