In variable state, the rate of flow of heat is controlled by

1.	In variable state, the rate of flow of heat is controlled by
A.	Density of material
B.	Specific heat
C.	40 m/s S?W
D.	All the above factors
Answer» E.

Discussion

No Comment Found

Related MCQs

A body cools in a surrounding which is at a constant temperature of \[{{\theta }_{0}}\]. Assume that it obeys Newton's law of cooling. Its temperature \[\theta \] is plotted against time t. Tangents are drawn to the curve at the points \[P(\theta ={{\theta }_{1}})\] and \[Q(\theta ={{\theta }_{2}})\]. These tangents meet the time axis at angles of \[{{\varphi }_{2}}\]and \[{{\varphi }_{1}}\], as shown
A composite metal bar of uniform section is made up of length 25 cm of copper, 10 cm of nickel and 15 cm of aluminium. Each part being in perfect thermal contact with the adjoining part. The copper end of the composite rod is maintained at \[{{100}^{o}}C\] and the aluminium end at \[{{0}^{o}}C\]. The whole rod is covered with belt so that there is no heat loss occurs at the sides. If \[{{K}_{\text{Cu}}}=2{{K}_{Al}}\] and \[{{K}_{Al}}=3{{K}_{\text{Ni}}}\], then what will be the temperatures of \[Cu-Ni\] and \[Ni-Al\] junctions respectively
One end of a copper rod of uniform cross-section and of length 3.1 m is kept in contact with ice and the other end with water at 100°C. At what point along it's length should a temperature of 200°C be maintained so that in steady state, the mass of ice melting be equal to that of the steam produced in the same interval of time. Assume that the whole system is insulated from the surroundings. Latent heat of fusion of ice and vaporisation of water are 80 cal/gm and 540 cal/gm respectively
Ice starts forming in lake with water at \[{{0}^{o}}C\] and when the atmospheric temperature is \[-{{10}^{o}}C\]. If the time taken for 1 cm of ice be 7 hours, then the time taken for the thickness of ice to change from 1 cm to 2 cm is [NCERT 1971; MP PMT/PET 1988; UPSEAT 1996]
The layers of atmosphere are heated through [MP PET 1986]
For proper ventilation of building, windows must be open near the bottom and top of the walls so as to let pass
If a liquid is heated in weightlessness, the heat is transmitted through [RPMT1996]
The coefficient of thermal conductivity depends upon [MP PET/PMT 1984; AFMC 1996; Orissa JEE 2005]
Heat current is maximum in which of the following (rods are of identical dimension) [Orissa JEE 2003]
One end of a metal rod of length 1.0 m and area of cross section \[100c{{m}^{2}}\] is maintained at \[{{100}^{o}}C.\]If the other end of the rod is maintained at \[{{0}^{o}}C\], the quantity of heat transmitted through the rod per minute is (Coefficient of thermal conductivity of material of rod =100W/m-K) [EAMCET (Engg.) 2000]

In variable state, the rate of flow of heat is controlled by

Discussion

No Comment Found

Related MCQs

Reply to Comment