In the cross-section of a weld, throat is the – McqOptions

MCQOPTIONS

1.	In the cross-section of a weld, throat is the
A.	minimum dimension
B.	average dimension
C.	maximum dimension
D.	none of the above
Answer» B. average dimension

Discussion

No Comment Found

Related MCQs

A steel beam supporting loads from the floor slab as well as from wall is termed as~!
The range of economical spacing of trusses varies from~!
Maximum pitch of rivets, used in steel stacks, is limited to (where t is thickness of thinner plate being connected)%!
If the 20 mm rivets are used in lacing bars, then the minimum width of lacing bar should be%!
*$_Bending compressive and tensile stresses respectively are calculated based on?
*$_The live load for a sloping roof with slope 15¬¨‚àû, where access is not provided to roof, is taken as?
*$_The capacity of the smallest pressed steel tank is?
*$_Lug angles?
*$_The minimum thickness of a steel plate, which is directly exposed to weather and is not accessible for cleaning and repainting, should be:?
*$_The overlap of batten plates with the main members in welded connections should be more than (where t = thickness of the batten plate)?