_If the specified thickness of a footing is 100 cm, the depth of the f – McqOptions

MCQOPTIONS

1.	_If the specified thickness of a footing is 100 cm, the depth of the form work may be tolerated from$?
A.	-2 mm to +2 mm
B.	-3 mm to +3 mm
C.	-4 mm to +4 mm
D.	-5 mm to +5 mm
Answer» E.

Discussion

No Comment Found

Related MCQs

While using three moments equation, a fixed end of a continuous beam is replaced by an additional span of__________________?
Which of the following methods of structural analysis is a force method ?
Which of the following methods of structural analysis is a displacement method ?
Which of the following is not the displacement method ?
When a uniformly distributed load, shorter than the span of the girder, moves from left to right, then the conditions for maximum bending moment at a section is that___________________?
When a uniformly distributed load, longer than the span of the girder, moves from left to right, then the maximum bending moment at mid section of span occurs when the uniformly distributed load occupies_______________?
When a series of wheel loads crosses a simply supported girder, the maximum bending moment under any given wheel load occurs when________________?
When a load crosses a through type Pratt truss in the direction left to right, the nature of force in any diagonal member in the left half of the span would_______________?
To generate the j the column of the flexibility matrix________________?
The width of the analogous column in the method of column analogy is _________________?