For the conjugate beam method to be applicable, which of the following

1.	For the conjugate beam method to be applicable, which of the following rules is not followed
A.	The original beam must be statically determinate
B.	The conjugate beam and original beam must be made the same length
C.	The conjugate beam must be static equilibrium
D.	No other loading should be applied to the conjugate beam other than the elastic weight
E.	The maximum indeterminacy can be upto 5 degree
Answer» F.

Discussion

No Comment Found

Related MCQs

A right solid circular cone standing on its base on a horizontal surface is of height H and base radius R. The cone is made of a material with specific weight W and elastic modulus E. The vertical deflection at the mid-height of the cone due to self-weight is given by
A simply supported beam of length 2L is subjected to a moment M at the mid-point x = 0 as shown in the figure. The deflection in the domain 0 ≤ x ≤ L is given by\(w = \frac{{ - Mx}}{{12EIL}}\left( {L - x} \right)\left( {x + c} \right)\)Where E is Young’s modulus, I is the area moment of inertia and c is a constant (to be determined).The slope at the centre x = 0 is
A hinged support in a real beam
A cantilever beam of length, L, with uniform cross-section and flexural rigidity, EI, is loaded uniformly by a vertical load, w per unit length. The maximum vertical deflection of the beam is given by
According to the principle of virtual work, If the system of rigid bodies is in equilibrium under the action of a set of forces, then the work done by those forces during a small virtual displacement of the system must be equal to
Macaulay's method is also known as:
A frame of two arms of equal length L is shown in the adjacent figure. The flexural rigidity of each arm of the frame is EI. The vertical deflection at the point of application of load P is
A force P is applied at a distance x from the end of the beam as shown in the figure. What would be the value of x so that the displacement at ‘A’ is equal to zero ?
A frame is subjected to a load P as shown in the figure. The frame has a constant flexural rigidity EI. The effect of axial load is neglected. The deflection at point A due to the applied load P is
A cantilever beam of length L is subjected to a moment M at the free end. The moment of inertia of the beam cross-section about the neutral axis is I and the Young modulus is E. The magnitude of the maximum deflection is.

For the conjugate beam method to be applicable, which of the following rules is not followed

Discussion

No Comment Found

Related MCQs

Reply to Comment