For masonry work with solid bricks, consistency of mortar should be? – McqOptions

MCQOPTIONS

1.	For masonry work with solid bricks, consistency of mortar should be?
A.	5 to 8 cm
B.	9 to 13 cm
C.	14 to 18 cm
D.	19 to 23 cm
Answer» C. 14 to 18 cm

Discussion

No Comment Found

Related MCQs

Water retentivity for brick masonry should not be less than%!
Cement mortars richer than 1 : 3 are not used in masonry because(i) There is no gain in strength of masonry(ii) There is high shrinkage(iii) They are prone to segregation%!
The mode of failure of a very short masonry member having h/t ratio of less than 4 is by%!
The basic stress in masonry units having height to width ratio of 1.5 may be increased by a factor of%!
Consider the following statements:A high lime content in a composite cement-lime mortar results in1. Slow hardening.2. Quick setting.3. Weaker mortar.%!
Assertion A : For identical strength, a composite cement-lime mortar is preferred over cement mortar.Reason R : Composite cement-lime mortar has higher drying shrinkage than cement mortar.Select your answer based on the codes given below. Codes:%!
Rich cement mortars are more liable to cracking as compared to lean mortars because rich mortars have%!
Assertion A : Lime based mortars give higher ratio of brickwork strength to mortar strength as compared to non-lime mortar.Reason R : Lime based mortars have lower bond strength as compared to non-lime mortars.Select your answer according to the codes given below:%!
*$_Water retentivity for brick masonry should not be less than?
*/*_If ‚Äö√Ñ√≤H‚Äö√Ñ√¥ is the height of wall between centers of supports, then the effective height of wall where concrete floors have a bearing on wall irrespective of the direction of span will be?