Design of shafts made of brittle material is based on

1.	Design of shafts made of brittle material is based on
A.	Guest's theory
B.	Rankine's theory
C.	St. Venant's theory
D.	Von Mises theory
Answer» C. St. Venant's theory

Discussion

No Comment Found

Related MCQs

Match the following criteria of material failure, under biaxial stresses \({\sigma _1}\), \({\sigma _2}\) and yield stress σy, with their corresponding graphic representations :A. Maximum-shear–stress criterion L. B. Maximum-distortion-energy criterionM.C. Maximum-normal-stress criterionN
Consider the following statements:1. In the infinitesimal strain theory, dilatation is taken as an invariant.2. Dilatation is not proportional to the algebraic sum of all normal stresses.3. The shearing modulus is always less than the elastic modulus.Which of the above statements is/are correct?
A structural element is subjected to pure shear of 80 N/mm2, as shown in the figure. The yield stresses both in tension and in compression are 240 N/mm2. According to the maximum normal stress theory, the factors of safety in tension and compression are, respectively,
According to the maximum shear stress failure criterion, yielding in material occurs when:
A rod of diameter 20 mm is subjected to a tensile load. Based on Tresca’s failure criterion, if the uniaxial yield stress of the material is 300 MPa, the failure load is
Principal stresses at a point in an elastic material are 1.5 σ (tensile), σ (tensile) and 0.5 σ (compressive). The elastic limit in tension is 210 MPa and μ = 0.3. The value of σ at failure when computed by maximum principal strain theory is, nearly.
According to the maximum strain energy theory, yield locus is _____.
A material may fail if_________.
From Rankine’s hypothesis Rankine, criteria for failure of brittle material is:
All the theories of failure, will give nearly the same result when

Design of shafts made of brittle material is based on

Discussion

No Comment Found

Related MCQs

Reply to Comment