Consider the following statements:(i) Quicksand is a special variety of sand(ii) Quicksand is not a material but a hydraulic condition.(iii) In nature, quicksand condition is observed usually in coarse silt or fine sand.Which of the above statements are correct?

Consider the following statements:(i) Quicksand is a special variety o

1.	Consider the following statements:(i) Quicksand is a special variety of sand(ii) Quicksand is not a material but a hydraulic condition.(iii) In nature, quicksand condition is observed usually in coarse silt or fine sand.Which of the above statements are correct?
A.	(i), (ii) and (iii)
B.	(i) and (ii)
C.	(ii) and (iii)
D.	(i) and (iii)
Answer» D. (i) and (iii)

Discussion

No Comment Found

Related MCQs

A uniform collapsible sand stratum, 2.5 m thick, has specific gravity of its sand as 2.65, with a natural void ratio of 0.65. The hydraulic head required to cause quick collapsible sand condition is
A stratum of 3.5 m thick fine sand has a void ratio of 0.7 and G of 2.7. For a quicksand condition to develop in this strata, the water flowing in an upward direction would require a head of:
A company has proposed to design a weir across a river in alluvial soil. The piezometric head at the bottom of the datum is computed as 10 m. The datum is 3 m below the floor bottom. The assured standing water depth above the floor is 2 m. The specific gravity of the floor material is 2.5. The required minimum thickness of the floor is:
Consider the following statements in the context of capillary pressure in soils:1. Pore water pressure is negative in capillary zone.2. Water is in tension in capillary zone.3. Capillary pressure in more in coarse grained soils.Which of the above statements are correct?
In a saturated clay layer undergoing consolidation with single drainage at its top, the pore water pressure would be the maximum at its
A flownet is drawn to obtain
Groundwater flows through an aquifer with cross-sectional and of 1.0 × 104 m2 and a length of 1500 m. Hydraulic heads are 300 m and 250 m at the groundwater entry and exit points in the aquifer, respectively. Groundwater discharges into a stream at the rate of 750 m3/day. Then the hydraulic conductivity of the aquifer is
An Isobar is
A 3 m thick soil stratum has 40% porosity. If the unit weight of soil at 12.2% water content is 18 kN/m3 , the total head required to cause quick sand condition is
A load of 6251 T is imposed on a footing of size 2 m × 2 m If it is to be assumed that, stress at depth "d" is spread out at an angle of 2 vertical to 1 horizontal, find out the depth 'd' at which the intensity of stress will be \({\left( {\frac{1}{9}} \right)^{th}}\) of the stress at ground level. Choose correct depth in metres from the following:

Consider the following statements:(i) Quicksand is a special variety of sand(ii) Quicksand is not a material but a hydraulic condition.(iii) In nature, quicksand condition is observed usually in coarse silt or fine sand.Which of the above statements are correct?

Discussion

No Comment Found

Related MCQs

Reply to Comment