Baretters and Bolometers are used for measurement of

1.	Baretters and Bolometers are used for measurement of
A.	VSWR
B.	Transmission losses
C.	Microwave power
D.	None of the above
Answer» D. None of the above

Discussion

No Comment Found

Related MCQs

In 'two-wattmeter method' of power calculation of a 3-phase balanced star connected system, what is the power factor of the system if both the wattmeter’s show a positive reading?
A 3-phase 10 kVA load has a power factor of 0.342. The power is measured by the two-wattmeter method.Find the reading of each wattmeter when the power factor is leading.
In two wattmeter method of power calculation of a 3-phase balanced star connected system, what is the power factor of the system, if both the wattmeters show the same positive reading?
A device capable of detecting voltage, current and the angle between the voltage and the current to provide power readings directly in watts is known as a/an:
A balanced 3-phase star-connected load draws power from a 440 V supply. The two watt-meters connected indicate W1 = 4.2 kW and W2 = 0.8 kW. Calculate the current in the circuit in Amperes
For a balanced load, the reactive power is measured by two wattmeter method with readings W1 and W2, the total reactive power is given by:
In a crossed coil power factor meter the moving coils should be mounted on which type of shaft and at what angles to each other?
A three-phase 10 kVA load has a power factor of 0.342. The power is measured by the two-wattmeter method.Find the reading of each wattmeter when the power factor is lagging.
For a delta-connected load being measured for power by the two-wattmeter method, if Iph will lead Vph by angle ϕ then it is the case of __________.
A dynamometer instrument is mainly used as

Baretters and Bolometers are used for measurement of

Discussion

No Comment Found

Related MCQs

Reply to Comment