MCQOPTIONS
Home
About Us
Contact Us
Bookmark
Saved Bookmarks
Testing Subject
General Aptitude
Logical and Verbal Reasoning
English Skills Ability
Technical Programming
Current Affairs
General Knowledge
Finance & Accounting
GATE (Mechanical Engineering)
Chemical Engineering
→
Electronics
→
Testing And Troubleshooting
→
An amplifier should have
1.
An amplifier should have
A.
High fidelity
B.
Low noise
C.
Stable operation
D.
All of the above
Answer» E.
Show Answer
Discussion
No Comment Found
Post Comment
Related MCQs
Phototransistors usually respond only to light in the red or infrared spectrum.
DC = IE/IC
In saturation, both the base-collector and base-emitter junctions are forward-biased.
Av RC/r'e
Both junctions of a BJT should be forward-biased for linear operation.
PD(max) is usually specified at 25°C. For higher temperatures, the value of PD(max) is greater.
It is best to check a transistor in-circuit before removing it.
If maximum IC and maximum VCE are applied to a BJT, maximum power dissipation will not be exceeded.
BJT transistors are of two general types, npn and pnp.
DC is the ratio of IC to IE.
Reply to Comment
×
Name
*
Email
*
Comment
*
Submit Reply
Your experience on this site will be improved by allowing cookies. Read
Cookie Policy
Reject
Allow cookies
