A welded rail joint is generally

1.	A welded rail joint is generally
A.	bull headed rails to the wooden sleepers
B.	flat footed rails to the cast iron sleepers
C.	none of these.
D.	supported on a sleeper
Answer» D. supported on a sleeper

Discussion

No Comment Found

Related MCQs

If is gauge distance and a is crossing, the distance between the nose of acute crossing and nose of obtuse crossing of a rail diamond, measured along the rail not forming the diamond, is
If is the distance between the parallel sidings and α is the angle of crossing, the distance between the noses of crossing measured parallel to the main track, is
If is the distance between the parallel sidings and β is the limiting angle of crossings, the distance between the noses of crossing measured parallel to the main track, is
If is the distance between the parallel sidings and α is the angle of crossing, the distance between the noses of crossing measured parallel to the gathering line, is
If α is switch angle and is radius of the turnout, the length of the tongue rail, is
On a straight railway track, absolute levels at point on two rails are 100.550 m and 100.530 m and the absolute levels at point B 100 m apart are 100.585 m and 100.515 m respectively, the value of twist of rails per metre run, is
Safe speed () on a curve of radius 970 metres provided with two transition curves on Board Gauge track, is
If absolute levels of rails at the consecutive axles , , and separated by 1.8 metres are 100.505 m, 100.530 m, and 100.525 m respectively, the unevenness of rails, is
If S is the switch angle and α is diamond angle, r is the radius of slip, the distance between middle point slip and the nose of obtuse crossing, is
If D is the distance between the parallel sidings and β is the limiting angle of crossings, the distance between the noses of crossing measured parallel to the main track, is

A welded rail joint is generally

Discussion

No Comment Found

Related MCQs

Reply to Comment