A structural member subjected to tensile force in a direction parallel – McqOptions

MCQOPTIONS

1.	A structural member subjected to tensile force in a direction parallel to its longitudinal axis, is generally known as
A.	A tie
B.	A tie member
C.	A tension member
D.	All the above
Answer» E.

Discussion

No Comment Found

Related MCQs

If L is the overall length of a combined footing having A as its area, d being the distance betweenthe centre of gravity of the base and centre of the base, the larger width b is
The maximum permissible slenderness ratio of compression member carrying dead andsuperimposed load, is
A single angle in tension is connected by one leg only. If the areas of connecting and outstandinglegs are respectively a and b, net effective area of the angle, is
Tacking rivets in compression plates not exposed to the weather, have a pitch not exceeding 300mm or
The ratio of the span L of the filler joists to the depth d from the underside of the joist to the topof the structural concrete, should not exceed
Spans of continuous fillers are considered approximately equal if the longest span does not exceedthe shortest span by more than
The maximum axial load which is just sufficient to keep a column in a small deflected shape, iscalled
If p and d are pitch and gross diameter of rivets, the efficiency ( ) of the riveted joint, is given by
When a load is transferred through one surface to another surface in contact, the stress is knownas
A simply supported beam carrying a central load, will be safe in deflection if the ratio of its span todepth, is