A solid steel plate having yield strength of 250 MPa, the design stren – McqOptions

MCQOPTIONS

1.	A solid steel plate having yield strength of 250 MPa, the design strength in yielding (N/mm2) is
A.	200
B.	217
C.	227
D.	250
Answer» D. 250

Discussion

No Comment Found

Related MCQs

If a tension member is subjected to possible reversal of stresses due to wind, the slenderness ratio of the member should not exceed -
According to IS 800, the maximum effective slenderness ratio for members always under tension (other than pre-tensioned members) is
A tie member consists of ISA 100 × 75 × 8 longer leg is connected to a gusset plate. The gross cross sectional area of connected and unconnected leg are _______ mm2 respectively.
A plate of size 100 mm x 10 mm having yield strength of 250 MPa, the design strength of plate in yielding of the cross-section is
Equal angles star section shown in the figure is designed as a compression member. Governing axis of the section is
Design strength in tension of a steel plate subjected to failure by rupture mode is expressed as:
As per IS: 800, the splice connection should be designed for a force of at least k times the member design capacity in tension. Here the value of k is:
Maximum slenderness ratio for tension members shall not exceed
In the case of structural steel sections (in terms of their outstanding length), the minimum ratio of thickness of elements in compression is specified to prevent
Lug angles ______