A single phase half wave rectifier is feeding a resistive load. Input – McqOptions

MCQOPTIONS

1.	A single phase half wave rectifier is feeding a resistive load. Input voltage v = Vm sin ωt. The output dc voltage is Vdc and output rms voltage is Vrms . If firing angle is 180°, Vdc and Vrms respectively are
A.	0 and 0
B.	[B].
C.	0 and - Vm
D.	[D].
Answer» B. [B].

Discussion

No Comment Found

Related MCQs

In a flyback converter, the inductor of the buck-boost converter has been replaced by a
The amount of dielectric heating is inversely proportional to frequency.
In current commutated DC-DC choppers, the voltage spike appears across the load when
Voltage commutation circuit can be converted into a current commutation by interchanging the positions of
The advantage of using free - wheeling diode in half controlled bridge converter is that
In a 3 phase half wave rectifier, when firing angle is less than 90 degree, then the average dc output voltage becomes
The input current waveform of a bridge controlled rectifier when the load is perfectly filtered is
If all the SCR s of 3 phase PAC is replaced by diodes, they would be triggered
A single phase step up cycloconverter changes 50 Hz to 100 Hz. Then one half wave of input will give rise to
A thyristor is reverse biased. A positive gate pulse is applied. The thyristor