A 220 V, d.c. motor draws an armature current of 20 A. Its armature resistance is 0.6 ohm. Then the induced emf in the motor will be

A 220 V, d.c. motor draws an armature current of 20 A. Its armature re

1.	A 220 V, d.c. motor draws an armature current of 20 A. Its armature resistance is 0.6 ohm. Then the induced emf in the motor will be
A.	195 V
B.	202 V
C.	208 V
D.	215 V
Answer» D. 215 V

Discussion

No Comment Found

Related MCQs

A bank of three single phase transformer can be used for obtaining the three phase output. Three magnetic circuits produced in case of a bank of three single phase transformer and in case of single phase transformer are
A 600kVA transformer has core losses of 1w at 25 Hz and 2.5w at 50 Hz (neglecting resistances and assuming flux density to be constant). The power required at 60 Hz is
A 600 kVA transformer has iron losses of 400 kW and copper losses of 500 kW. Its kVA rating for maximum efficiency is given by
A 6 pole wave wound d.c. generator has 460 armature conductors carrying armature current of 180 A. The armature reaction demagnetizing and cross magnetizing ampere turns per pole if brushes are shifted by 6 degree electrical from G.N.A are
A 6 kVA, 220 v 3 phase, star connected synchronous generator has a winding resistance of 0.15 ohm per phase and synchronous reactance of 6.1 ohm per phase. The voltage regulation of alternator at a load power factor of 0.8 lagging will be
A 5kV / 250V, 50Hz single phase core type transformer with average flux in the core is 0.05wb. The number of turns in the primary winding is
A 500 kVA single phase transformer has 90% efficiency at both half load and full load at unity power factor. Then iron losses will be
A 50 Hz, 3 phase slip ring induction motor, has 6 poles on stator and 4 poles on rotor. Then the machine will run at
A 50 Hz, 3 phase induction motor with 4 pole stator is supplied by mains, which contains a pronounced fifth time harmonic. The speed of the fifth space harmonic will be
A 400v, 4 pole, 3 phase, 50 Hz star connected induction motor has a rotor resistance and reactance per phase equal to 0.02 ohm and 0.2 ohm respectively. Then the slip at which maximum torque occurs and the corresponding maximum torque is (assuming stator to rotor turns ratio as 6)

A 220 V, d.c. motor draws an armature current of 20 A. Its armature resistance is 0.6 ohm. Then the induced emf in the motor will be

Discussion

No Comment Found

Related MCQs

Reply to Comment