MCQOPTIONS
Home
About Us
Contact Us
Bookmark
Saved Bookmarks
Testing Subject
General Aptitude
Logical and Verbal Reasoning
English Skills Ability
Technical Programming
Current Affairs
General Knowledge
Finance & Accounting
GATE (Mechanical Engineering)
Chemical Engineering
→
Electronics
→
Testing And Troubleshooting
→
1 mW in dBm is:
1.
1 mW in dBm is:
A.
0 dBm
B.
-30 dBm
C.
30 dBm
D.
1 dBm
Answer» B. -30 dBm
Show Answer
Discussion
No Comment Found
Post Comment
Related MCQs
Phototransistors usually respond only to light in the red or infrared spectrum.
DC = IE/IC
In saturation, both the base-collector and base-emitter junctions are forward-biased.
Av RC/r'e
Both junctions of a BJT should be forward-biased for linear operation.
PD(max) is usually specified at 25°C. For higher temperatures, the value of PD(max) is greater.
It is best to check a transistor in-circuit before removing it.
If maximum IC and maximum VCE are applied to a BJT, maximum power dissipation will not be exceeded.
BJT transistors are of two general types, npn and pnp.
DC is the ratio of IC to IE.
Reply to Comment
×
Name
*
Email
*
Comment
*
Submit Reply
Your experience on this site will be improved by allowing cookies. Read
Cookie Policy
Reject
Allow cookies
